Skip to content
ESPresense

M5Stack DLight

SensorsBH1750FVI: ambient light
ConnectionGROVE I2C (0x23)

Template

Section titled “Template”

First apply your board's template from its board page, so the I2C pins are set. Then paste this into the Board Template box on the node's Templates page, Preview and Apply. It sets only this add-on's settings and works on any chip. See Add-on templates.

{"settings":{"BH1750_I2c_Bus":1,"BH1750_I2c":"0x23"}}

Notes

Section titled “Notes”
  • Plug it into the GROVE port. The Atom S3 Lite and NanoC6 board templates set GROVE as I2C bus 1. On another board, set I2C bus 1’s SDA and SCL pins on the Hardware page first.
  • Applying the template needs firmware newer than v5.0.0b2 (ESPresense#2555). Older firmware asks for a "chip"; set the values on the Hardware page instead.
  • Publishes bh1750_lux.